Testing
Detection Scope
2m 4m 6m 8m0m
0m
2m
110°
Press the test button at the back of the PIR Sensor, walk from left to right within the
detection scope to check that the Sensor is working. The LED indicator light will
light up when movement is detected. When in Test Mode, the Sensor will search for
movement every 10 seconds. The Test Mode duration is 3 minutes.
Adjusting the position of the PIR Sensor on the bracket will affect the detection range.
The detection range can be adjusted to meet your individual requirements, as shown
in the diagrams below.
Adjusting the Detection Range
Top view
Side view
Side view
Top view
Note: If used in a pet friendly environment, for best results keep the PIR parallel to the
wall, do not tilt it up or down.
50
To Next Page
Loading...
