24
1
2
3
3
4
1
2
3
4
2. Add/Delete/Edit Accessories
The Control Panel will only receive a signal from an accessory once connected to the
Control Panel.
Add/Delete Remote Controls or Wireless Keypads
Add
Log into the menu, press or , choose “Accessories”, press . [ ] [ ] [Enter]
Press or , choose “Remote & Keypad”, press . [ ] [ ] [Enter]
Press or , choose “Add”, press .[ ] [ ] [Enter]
The LCD display will show “Please connect”, press any button on the Remote Control
or Keypad to enable signal transmitting to the Control Panel. When a single beep is
heard, the LCD display will show “Remote (01-10)”, connection succeeded.
2 beeps indicate that the Accessory is already connected to the Control Panel.
Delete
To delete Remote Controls or Wireless Keypads, refer to “Delete” in step as above
and press Then choose to delete all or specific Remote Controls or Wireless [Enter].
Keypads, press again. [Enter]
Add/Delete/Edit RFID Tags
Add
Log into the menu, press or , choose “Accessories”, press . [ ] [ ] [Enter]
Press or , choose “RFID Tag”, press . [ ] [ ] [Enter]
Press or , choose “Add”, press .[ ] [ ] [Enter]
The LCD display will show “Please connect”, place the RFID Tag close to the RFID
Reader on the Control Panel. When a beep is heard, the LCD display will show “RFID
(01-50)”, connection succeeded. When 2 beeps are heard, it means this accessory is
already connected to the Control Panel.
Delete
To delete an RFID Tag, select “Delete” in step as above and press . Then [Enter]
choose to delete all or specific RFID Tags and press again. [Enter]
3
To Next Page
Loading...
