25
1
2
3
4
1
2
3
4
5
6
3
Edit
To rename an RFID Tag, choose “Edit Name” in step as above and press , [Enter]
then input the name.
Add/Delete/Edit Wireless Sensors
Add
Log into the menu, press or , choose “Accessories”, press . [ ] [ ] [Enter]
Press or , choose “Wireless Sensors”, press . [ ] [ ] [Enter]
Press or , choose “Add”, press .[ ] [ ] [Enter]
The LCD display will show “Please connect”. Trigger the Sensor once to make it send a
wireless signal to the Control Panel. When a single beep is heard the LCD display will
show “Sensor (01-50)” connection succeeded. When 2 beeps are heard, it means the
accessory is already connected to the Control Panel.
Delete
Edit Sensor Type
Log into the menu, press or ,choose “Accessories”, press . [ ] [ ] [Enter]
Press or , choose “Wireless Sensors”, press . [ ] [ ] [Enter]
Press or , choose “Edit”, press .[ ] [ ] [Enter]
Press or , choose “Sensor 01-50”, press .[ ] [ ] [Enter]
Press or , choose “Edit Sensor Type”, press .[ ] [ ] [Enter]
Press or , choose one type of “Normal Sensor/ 24 Hour Sensor/ Delay [ ] [ ]
Sensor/ Home Sensor”, press . [Enter]
Note: [*] In the event of incorrectly inputting the name press the button on the Control Panel to
clear down and start again . Press the to exit.[ESC]
To delete Sensors, refer to “Delete” in step as above and press Then choose [Enter].
to delete all or specific Wireless Sensors, press again. [Enter]
3
To Next Page
Loading...
