40
Part-Arm (Home Mode)
Monitor
Send “2" to Part Arm the System. Sensors set to the home mode zone are in disarmed
status; all other Sensors remain in armed status. That is, you can move freely around
areas of your property where the Sensors are set to a ‘home mode’ zone; however, all
Sensors set to a ‘normal zone’ will remain active and if triggered will activate the Control
Panel.
Send “3" for remote monitoring by call-back from the Control Panel.
When the Control Panel receives an SMS message, it calls out to the stored phone
number. When answered you can monitor (listen in) to the property.
2
Mobile phone home mode
3
Recording Voice Memo
Send “4" to record a Voice Memo. After the Control Panel receives the SMS it will call
your phone number. Upon answering you can commence recording your 10-second
voice memo.
Note: The Control Panel will disconnect the call after 10 seconds, even if you are still
recording your voice message.
4
To Next Page
Loading...
