37
1
2
2
3401
1401
1409
1132
1131
1100
1120
3456
1137
1144
1140
1133
1384
1302
1301
3
Upload Arm/ Disarm Report to CMS Centre
When this function is enabled, all arm/disarm reports will be uploaded automatically to
the CMS centre to notify of the alarm system status.
After the User ID is set, press or to choose “Arm Upload” or “Disarm Upload”, [ ] [ ]
press .[Enter]
Press or , Choose “On”, press .[ ] [ ] [Enter]
When choosing “Off” during setup , press , an arm/ disarm report will not be [Enter]
uploaded to a connected CMS centre.
Contact ID Reports
Arm
Disarm
Disarm by RFID Tag
PIR Sensor alarm
Door Sensor alarm
Emergency call
Duress alarm
Part Arm (Home mode)
Control Panel tamper alarm
Sensor tamper alarm
Normal zone alarm
24H zone alarm
Sensor low battery
Control Panel low battery
Control Panel AC failure
Event Code
Event Event
Event Code
Remote Phone Control
The system can be controlled at the Control Panel and with a Remote Control. In
addition the system can be remotely controlled by telephone call, SMS or App.
Remote phone control can be achieved in two ways:
Answering Alarm Telephone Call to Start Remote Control
When an alarm is triggered the Control Panel will auto-dial the stored phone
numbers. When answering the call, the user will hear the pre-recorded alert voice
message (if one is set). Press one of the keys shown on the next page to operate the
system remotely. The Control Panel will make up to three rounds of calls to the stored
numbers. When the user presses any of the keys shown in the instruction table, the
Control Panel will stop dialling-out. If the call is unanswered the system will stop
dialling out after three rounds of calls.
To Next Page
Loading...
