Kit Contents
The Dual Network Control Panel receives and
processes signals from wireless Sensors and Remote
Controls. Settings can easily be changed following
the quick programming guide displayed on the LCD
screen. When users pick up an alarm notification call
they will hear the pre-recoded alarm voice message,
from which they can choose to either monitor on-site
or to disarm the system.
Control Panel
01
Should the PSTN network be unavailable, the E11 panel will automatically switch to the
GSM network..
Sensors are triggered or the SOS button
on the Remote Control is activated
Control Panel alarms and
the built-in siren sounds
Notification cycle :
Users receive push notifications and
SMS Messages if a SIM Card is installed
Control panel will dial the pre-stored alarm
phone numbers automatically
To Next Page
Loading...
