35
1
2
Reset
Log into the menu, press or , choose “System Settings”, press .[ ] [ ] [Enter]
Press or , choose “Reset”, press to reset the system to default setting. [ ] [ ] [Enter]
Note: All system settings will be restored to the default factory setting but the paired Sensors
will remain working.
In the event of the Admin Code being lost and the administrator not being able to
access the system to edit settings, please contact the Customer Support Helpline.
4. Check Event Logs
Note: [ ] [ ]Hold or to skip a logged event.
Up to 150 past events can be tracked/viewed.
Log into the menu, press or , choose “History”, press .[ ] [ ] [Enter]
Press or , select the event you want to view, press . The event log time [ ] [ ] [Enter]
and alarm location will be shown.
Connection to an Electronic Lock
An Electronic Lock when connected to the system for access control purposes, will
send an “On/Off” (lock/unlock) signal to the Control Panel.
Please refer to your door lock manual for compatibility and connection instructions.
1
2
To Next Page
Loading...
