28
Exit Delay
Exit Delay is set to leave time for user to exit the property before the system is armed.
Log into the menu, press or , choose “System Settings”, press . [ ] [ ] [Enter]
Press or , choose “Entry Exit Delay”, press .[ ] [ ] [Enter]
Press or , choose “Exit Delay”, press .[ ] [ ] [Enter]
Input time for exit delay; press for confirmation.[Enter]
The Exit Delay time is calculated in seconds; default is 0 second (off); setup range is 0-
999 seconds.
Note: Once the delay time is set, when arming the system, one beep will be heard every
second to remind the user to leave the property , the beep interval will speed up during the
last 15 seconds. A Delay time is unavailable for Sensors set to the 24-hour zone.
Backlight Time
To set the LCD screen backlight standby time:
Log into the menu, press or , choose “System Settings”, press . [ ] [ ] [Enter]
Press or , choose “Backlight Time”, press .[ ] [ ] [Enter]
Input time for backlight time; press .[Enter]
Timed Arm / Disarm
The user can set timed arm and disarm according to their daily schedule to avoid
repeated operation.
Timed Arm
Log into the menu, press or , choose “System Settings”, press . [ ] [ ] [Enter]
Press or , choose “Auto Arm/Disarm”, press .[ ] [ ] [Enter]
Press or , choose “Auto Arm Time”, press .[ ] [ ] [Enter]
Input exact time for arming; press .[Enter]
Backlight time is calculated on seconds; default is 20 seconds; setup range is 01-99
seconds.
1
2
3
4
1
2
3
1
2
3
4
Note: For Sensors set to the 24-hour zone, a timed entry/exit delay cannot be set (refer to
page 30)
Input time for entry delay; press for confirmation.[Enter]
Entry delay time is calculated on seconds; the default is 0 second (off); the set-up
range is 0-999 seconds.
4
To Next Page
Loading...
