25 / 70
6 • Remedying malfunctions
80116-941_V24392
2023-03
I/I-A error
IMPORTANT! I errors are output with the identification number of the originating
socket slots = I X (slots are counted from top to bottom -> VIO 3: 1, 2, 3,
4, APC 3: 5, 6). The NE slot is not included during counting as this
assembly generates its own error messages (see N errors).
Display on the unit: I or I-A, detecting module: IIM
Error code Description Additional information Action
I 1 CRC check triggers an
alarm.
Restart the unit. If the
error occurs again, notify
Erbe Service.
I 5 – 7 Restart the unit. If the
error occurs again, notify
Erbe Service.
I 10 D-Flash programming
error.
Restart the unit. If the
error occurs again, notify
Erbe Service.
I 11 P-Flash programming
error.
Restart the unit. If the
error occurs again, notify
Erbe Service.
I 39 Undefined (impermissi-
ble) connector detection/
faulty socket.
From V 1.1.x. Check the accessories. If
the error continues to
occur, check the accesso
-
ries and affected socket.
I 45 – 50 Restart the unit. If the
error occurs again, notify
Erbe Service.
I 57 –63 Restart the unit. If the
error occurs again, notify
Erbe Service.
I-A 30 1-wire, CRC incorrect. Check the accessories. If
the error persists, notify
Erbe Service.
I-A 31 1-wire, type incorrectly
detected.
Check the accessories. If
the error persists, notify
Erbe Service.
I-A 32 1-wire, no Erbe instru-
ment.
Check the accessories. If
the error persists, notify
Erbe Service.
I-A 33 Short circuit, IK (instru-
ment recognition) line.
Check the accessories. If
the error persists, notify
Erbe Service.
To Next Page
Loading...
Need help?
General
