How to use this device
10/2020 1020217-00A Operating instructions – 67/96
Low pressure lamps
WARNING!
Danger of burns from hot lamps and device parts!
If the tanning device was operated before bein
switched off
and opened, lamps and housing parts may be hot.
– Before replacing lamps or other spare parts, wait until
lamps and metal parts of the device have cooled down
sufficiently.
Replace faulty low pressure lamps immediately.
Always replace the entire set of lamps after the specified operating time.
– Turn 90° and carefully remove from the socket.
– Low pressure lamps possess a reflector which directs the light outwards.
The lamps must be mounted in such a way that the rear side of the re-
flector is located on the device side.
– Push the pins vertically into the socket from above.
To Next Page
Loading...
