ESAB ET 201i DC - Page 3

!
WARNING
Read and understand this entire Manual and your employer’s safety practices before installing, operating, or
servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best judgement, the Manufac-
turer assumes no liability for its use.
i
Welding Power Supply
Operating Manual Number 0-5452 for:
ESAB ET 201i DC Power Source Arc Welder Part No. W1003806
ESAB ET 201i DC System with Stick/TIG Kit & Case Part No. W1003807
Published by:
ESAB Group Inc.
2800 Airport Rd.
Denton, TX 76208
www.esab.com
Copyright © 2015 by
ESAB
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the publisher
is prohibited.
The publisher does not assume and hereby disclaims any liability to any party for any loss
or damage caused by any error or omission in this Manual, whether such error results from
negligence, accident, or any other cause.
For Printing Material Specication refer to document 47x1909.
Publication Date: March 30, 2016
Revision Date:
Record the following information for Warranty purposes:
Where Purchased: ____________________________________
Purchase Date: ____________________________________
Equipment Serial #: ____________________________________