EasyManua.ls Logo

ESI 600 - Basic Phone Operation Steps

ESI 600
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ESI Feature Phone operation User’s Guide
E.4
Basic phone use
Outside calls
To answer (double-ring cadence): Lift the handset or press SPEAKER. If using a Cordless Handset,
either press TALK or remove the Cordless Handset from its charging cradle.
To place: Lift the handset or press SPEAKER. Then either press an unlit line key or dial 9 (or 8 or
71–76)
1
to be assigned an outside dial tone. On a Cordless Handset, press TALK and dial 9 (or 8 or
71–76)
1
To hang up: Replace the handset or press RELEASE or — if using the speakerphone —
press SPEAKER. If using a Cordless Handset, press TALK or put the Handset in its charging cradle.
Important: If you’re using a VoIP-enabled system, be aware that your outside phone lines’ quality can affect
the audio quality of local and Remote IP Feature Phone(s). Due to the interface between
advanced, packet-based phone systems and the traditional public telephone network, a poor-
quality phone line can degrade audio quality, causing an echo on outside calls. An occasional
echo isn’t unusual and doesn’t necessarily indicate a problem with your system or lines; however,
if this problem occurs persistently, contact your Certified ESI Reseller for assistance.
Internal calls
To answer (single-ring cadence): In hands-free mode, answer directly through the speakerphone or
pick up the handset. Or, to answer a ringing call, lift the handset or press SPEAKER. If using a
Cordless Handset, either press TALK or remove the Cordless Handset from its charging cradle.
(To receive a “hands-free-answer” call on a Cordless Handset, you must be using a headset.)
To place: Lift the handset and dial the extension number or press a station key (see “Direct station
selection,” page E.5). On a Cordless Handset, press TALK or dial the extension.
To hang up: Replace the handset or press RELEASE or press the station key again or — if using the
speakerphone — press SPEAKER. If using a Cordless Handset, press TALK or put the Handset in its
charging cradle.
Shortcut for either outside or internal calls on speakerphone-equipped ESI phones:
If you press a station key or dial an extension number, the phone system automatically activates
the speakerphone.

Table of Contents

Related product manuals