User’s Guide Analog stations
J.7
Analog station programming
After logging into your mailbox (pressing
followed by the mailbox number), dial 5 to program.
1 Select personal greeting
Select the desired greeting number: 1, 2 or 3. The system will prompts to re-record, delete, hear, or
select as the current greeting by pressing #.
1 Record personal greeting
Begin recording at the tone; press 1 to stop. The new personal greeting automatically replaces
the previous greeting.
Note: Your mailbox will be disabled if no personal greeting exists.
2 Delete personal greeting
When prompted, press 2 again to confirm deletion.
Warning: Don't delete all of your greetings. If you do, the system will turn off your mailbox until there
is once again at least one greeting.
3 Hear current personal greeting
3 Call waiting
1 Enable call waiting
0 Disable call waiting
5 Password
The password will apply to station programming, voice mail retrieval and certain other features
(when activated).
1 Enter new password
Your password may consist of 2–8 digits followed by # (0 cannot be the first digit). Entering 0
(zero) as the sole password will turn off the password requirement.
2 Delete current password
3 Hear current password
4 Password security level
Select one of the following password levels.
Selection Result
0 No password required for access from any phone
1 Password required only for remote access, either off-premises or from other
stations within the system
2 Password always required
To Next Page
Loading...
