User’s Guide ESI Feature Phone operation
E.9
Any member of the conference can drop out by simply hanging up. However, when the station that
created the conference hangs up, all members in the conference are disconnected. Individual stations
or lines connected to the conference can be dropped from the conference by pressing their station or
line key (lit green).
Note: Your installer or System Administrator may have enabled trunk-to-trunk conferencing (unsupervised
conferencing) for your station. If so, the steps to initiating such a conference are the same as for
performing any other conference (see above); the difference is that you may hang up, thus exiting the
conference, but the remaining members won’t be disconnected. (If this feature isn’t enabled, your
hanging up disconnects all members.)
Important: USE OF FEATURES, SUCH AS TRUNK-TO-TRUNK TRANSFER, THAT REQUIRE TRUNK-TO-TRUNK CONNECTIONS
WILL INCREASE THE RISK OF TOLL FRAUD. IN NO EVENT SHALL ESTECH SYSTEMS, INC. BE LIABLE FOR ANY
DIRECT, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES WHATSOEVER INCLUDING, BUT NOT LIMITED
TO, FRAUDULENT TOLL CHARGES, LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTIONS, OR ANY OTHER
COSTS OR DAMAGES RELATED THERETO, ARISING FROM THE USE OF THESE FEATURES.
Privacy release
This feature makes it easy to “conference-in” on a call: just press a line key assigned to the outside line
the call is using, and you’ll automatically join the call.
1
Call forwarding
Your station has been pre-programmed by the installer to “call-forward” your phone when it is busy or
does not answer (usually to your mailbox). In addition, you can temporarily call-forward all of your calls
to another station or another user’s mailbox.
On the 24-Key Feature Phone or an ESI Cordless Handset:
1. Assign code 5 6 5 to a programmable feature key (see “Programmable feature keys,” page C.2).
This will make it a “call-forward all-calls” key.
2. Press the key you programmed in the previous step and dial the extension number (or VOICE MAIL
and then the mailbox number) to which the system should forward all calls.
On the 48-Key Feature Phone, press CFWD to use the call forwarding feature.
To turn off call forwarding, press CFWD
.
2
Note: If the forwarded-to station is busy or does not answer a forwarded call, the call will be returned to
your mailbox.
If you frequently call-forward your phone, you can program a programmable feature key as a call forwarding
key to automatically turn forwarding on and off. If you always forward to the same extension, you can
program a key with both 5 6 5 and the extension number. (For more information, see “Programmable
feature keys,” pp. C.2–C.3.) The call forwarding key will be solid green to indicate that it is active.
(Continued)
1
This feature may not be available on your system, depending on how it has been programmed. If you wish to enable this feature
on your phone system, contact your System Administrator.
2
As an alternative (especially on phones without the CFWD key), dial 5 6 5
without selecting a destination and then hang up.
To Next Page
Loading...
