Troubleshooting
84
Platinous User’s Manual
8.1 Troubleshooting Using Alarm Codes
ELECTRIC SHOCK! Before intervening with power circuits, shut
OFF primary power supply at the primary switch.
Working with primary power supply ON runs the risk of electric shock.
Shut OFF power from the main power breaker BEFORE opening
the electric parts compartment door or the water circuit
compartment door.
The Platinous Series is equipped with an alarm that sounds when problems occur as well as self-check
features which appear on the instrumentation panel display. Display alarm codes and their content are
given in the alarm table on the following pages. Follow the steps as indicated.
For problems not found with self-checks, See “Operator Error and Additional Troubleshooting” on page 95.
If the issue is not resolved after taking the prescribed action, contact the place of purchase or Espec North
America.
8.1.1 When an Alarm Occurs
The chamber will be in one of the states listed below when an alarm occurs. The alarm is cleared in a
different way depending on what your needs are at that time. Procedures for clearing the alarm in each of
these cases are given on the following pages.
•Running in the constant mode
•Running in the program mode but not needing to continue after clearing the alarm
•Running in the program mode and needing to continue after clearing the alarm
To Next Page
Loading...
Need help?
General
