Estun E200P User Manual

E200P Operation Manual
22
Parameter Default Range Unit Description
DLY 0~99.99 s
In case of single step, delay
time for X-axle retracting.
PP 0~9999 -
The number of processing
workpiece in this program.
CP 0~9999 -

PP=0: this value is the
current work piece.

PP>0: this value is the
remain work piece.
OPN 0~999.999 mm/inch
After bending, the distance
of the Y-axis opening.
PROGRAM
ST 0~25 -
The total number of steps in
this program.
PP 0~99999 -
The number of processing
workpiece in this program.
CP 0~99999 -

PP=0: this value is the
current work piece.

PP>0: this value is the
remain work piece.
DLY 0~99.99 s
In case of single step, delay
time for X-axle retracting.
HT 0~99.99 s
The interval time from LDP
signal to decompression
process.
STEP
XP
0~9999.999
mm/inch
Program position of X axis.
YP
0~9999.999
mm/inch
Program position of Y-axis.
DX
0~9999.999
mm/inch
Retract distance of X axle.
OPEN DIST 0~999.999 mm/inch
After bending, the distance
of the Y-axis opening.
Repeat Times 1~99 -
The repeat times in this
step.

Estun E200P Specifications

General

Brand	Estun
Model	E200P
Category	Controller
Language	English