30
CV Name Description Range Value
49 Relay control
(only with SwitchPilot
Extension)
(Details in chapter 12)
Configuration, which relay is to be switched decelerated. 0 - 15
SPS: 15
SP:
0
If Bit active, relay switches between „A“ and „B“.
Bit Description Value
0 Relay 1 decelerated switch (addit. SwitchPilot: Switches with 2nd addr.) 1
1 Relay 2 decelerated switch (addit. SwitchPilot: Switches with 2nd addr.) 2
2 reserved 4
3 reserved 8
50 Impuls-Configuration Defines how the pulse signale is applied to the servo 0-7 0
Bit Description Value
0 Initial pulse signal after command received 1
1 Timeout impulse after position reached 2
2 Power on servo only while moving 4
List of all supported CVs
To Next Page
