8
10
9
8. Secure the gas spring in accordance with the illustrations for
”Screw positions for seat depth”.
Do not forget the washer in between. NB! If fitted
into the wrong hole, the back support adjustment will
not function correctly.
9. Raise the chair up and remove the Allen key used to lock the back
support angle.
10. Fit the seat plates in accordance with the illustrations for ”Screw
positions for seat depth”. Start with
the rear seat plate.
11. Fit rear wheels, arm support and seat cushion.
12. Engage the anti-tips and check the seat and back angling
function.
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
7. Settings
Seat depth, rear
To Next Page
Loading...
