ETC Express 24/48 - Chapter 20 Diskette functions

Express Two Scene Preset User Manual, v.3.1 229
Follow these steps to create a macro to record a show to diskette:
Macro wait
To program a pause in the macro, press [Macro Wait] at the point in the
macro where you want the pause to occur. Enter the time you would like
the macro to hold, then press [Enter]. Continue to enter remaining macro
commands.
To program a pause in the macro, in the Macro Editing display, press [S7],
More Softkeys, and insert [S8], Macro Wait, at the point in the macro
where you want the pause to occur. Enter the time you would like the
macro to hold, then press [Enter].
Times may be expressed in minutes and seconds, or as fractions of sec-
onds (in decimal format). Times can be programmed from 0.1 seconds to
99:59 minutes. Acceptable time values include: 0.2 (.2 seconds), 00:12
(12 seconds), 5.5 (5.5 seconds), or 5:30 (five minutes, 30 seconds).
Keystrokes: Action:
1. Press [Setup]. Selects Setup display screen
2. Select 8, Macro Editing,
and press [Enter].
Selects Macro display screen
Prompt reads:
Select macro number, then press
ENTER
3. Press [8] [Enter]. Blank macro created
Prompt reads:
Select operation(s) for this macro –
press ENTER MACRO when done
(Wheels, trackpad and sliders are
not valid entries in macros)
4. Press [Setup] [3] [Enter]. Enters setup display
Macro contents line reads: SETUP 3
ENTER
5. Press [1] [Enter]. Selects Write Show To Disk
Macro contents line reads:
SETUP 3 ENTER 1 ENTER
6. Press [Enter]. Confirms selection
Macro contents line reads:
SETUP 3 ENTER 1 ENTER ENTER
7. Press [Enter Macro]. Stores macro 8