ETC Express 24/48 - Manual crossfades

Express Two Scene Preset User Manual, v.3.1 247
Read show components only
Frequently you do not need to overwrite system configuration settings
but only want a different showfile in console memory. For that purpose,
read show contents only into memory with the following procedure:
Read system configuration components only
Follow the procedure below if you want to restore your system
configuration to one written previously to a diskette.
103
Keystrokes: Action:
1. Insert diskette in disk
drive.
2. Press [Setup]. Selects Setup display
3. Press [3], Disk Functions,
[Enter].
Selects Diskette Functions menu
4. Press [2], Read Show
From Disk, [Enter].
Screen clears and Read Show window
appears
5. Press [Enter], or press
[Clear] to cancel the
operation.
Message in record window appears
and remains until read is complete:
From disk in progress.
103.
System configuration information was not saved on diskette for shows recorded
prior to version 3.03 software.
Keystrokes: Action:
1. Insert diskette in disk
drive.
2. Press [Setup]. Selects Setup display
3. Press [3], Disk Functions,
[Enter].
Selects Diskette Functions menu
4. Press [3], Read System
Configuration From Disk,
[Enter].
Screen clears and Read System
Parameters window appears
5. Press [Enter], or press
[Clear] to cancel the
operation.
Message in record window appears and
remains until read is complete:
Read system configuration in
progress.