30 Chapter 3 System settings
Scene mode
The console’s operating mode may be one scene or two scene. The
default condition is one scene mode. See Chapter 23 Two scene preset,
page 257, for information about setting the scene mode.
Follow these steps to put the console in the desired operating mode.
Keystrokes: Action:
1. Press [Setup] [1] [Enter]. Selects System Settings menu
2. Press [15] [Enter].
a
a. If your console is an Express 24/48, the prompt that
appears at step 2 reads
Select scene mode, then
press ENTER (1 = Two scene, 2 = One scene without
subs, 3 = One scene with subs)
. Selection 3 sets the
bottom row of sliders to submasters rather than
channel sliders when you are in the one scene mode.
Prompt reads:*
Select scene mode, then press
ENTER
(0 = One scene, 1 = Two scene)
3. Press [1] [Enter]. Two scene mode is enabled
To Next Page
Loading...
