ETS-Lindgren EMCenter - 8 Remote Control of the Emcenter; First Character: Identifier

www.ets-lindgren.com Remote Control of the EMCenter
33
8.0 Remote Control of the EMCenter
 All commands for plug-in cards must have a two-character prefix:
 First character: Identifies the type of card.
 Second character: Provides the device number of the card.
Terminate each command with a carriage return (CR).
First Character: Identifier
The following table provides the first character or identifier for the EMCenter™
Modular RF Platform cards.
Plug-in Card Identifier Description
7004-004 P Dual Laser Power Supply Card
7001-00n S EMSwitch Card (All)
7004-00n L <Future use>
7003-00n G <Future use>
7002-001 X EMPower Meter Plug-in Card
7002-00n W EMPower Sensor (All)
7006-001 EMControl Positioner Control Plug-in Card
7007-001 EMSense EMF Probe Plug-in Card, Battery
To control a device installed in the EMCenter from a remote computer
using the GPIB interface, the IEEE address of the EMCenter must be
set correctly.
To control a device installed in the EMCenter from a remote computer
using the USB Interface, a USB Driver must be installed on the remote
computer. See Using the USB Interface.