36
Remote Control of the EMCenter www.ets-lindgren.com
Command Set and Error Codes
Following are the general commands and error codes for the EMCenter. For
device-specific commands, see the separate manual for each card.
COMMAND SET
Command Message Description
*IDN? Request the identification of the EMCenter
Response: ETS-Lindgren EMCenter version x.x.xx
STATUS? Request the status of the EMCenter; reply is
device-specific
LOCAL Return to local mode
REBOOT SYSTEM Reboot the EMCenter
ERROR CODES
Error Code Description
ERROR 1 Internal buffer overflow
ERROR 2 Command too long
ERROR 3 Invalid command
ERROR 4 Command too short
ERROR 5 Invalid parameter
ERROR 6 Parameter too high
ERROR 7 Parameter too low
ERROR 8 Hardware failure
ERROR 9 Reserved
ERROR 10 Reserved
ERROR 20 Unknown device type
ERROR 21 Unknown device number
To Next Page
Loading...
