EUCHNER CET-AS Series - Page 17

17
2113689-04-07/19 (Translation of the original operating instructions)
Operating Instructions
Transponder-Coded Safety Switch CET.-AS-…
EN
Note the following points:
Actuator and safety switch must be tted so that
Ì the active faces of the actuator and the safety switch are parallel with each other.
Ì the actuator is fully inserted into the switch recess when the guard is closed.
Ì no dirt can accumulate in the recess.
Tip!
EUCHNER offers special cover plates to improve protection against tampering. These accessories
can be found at www.euchner.com.
!
= 90°
!