EN 03
Get Started
C
B
A
D E
F
Remove power cords and small objects from the floor that may entangle RoboVac.
Fold tasseled edges of rugs underneath to prevent tangling RoboVac. Avoid cleaning high-pile rugs or
rugs thicker than 1.02 in / 26 mm as they may cause RoboVac to malfunction.
It is strongly recommended to place physical barriers or set a “No-Go” zone via the eufy Clean app in
front of fireplaces, the edge of staircase, and certain areas (i.e. air vents) that may cause damage to
RoboVac if entered.
a
b
c
Avoid vacuuming large amounts of water as it may damage the device.
RoboVac may climb on top of objects less than 0.7 in / 18 mm in height. Remove these objects if possible.
Anti-drop sensors will prevent RoboVac from tumbling down stairs and steep drops in most cases.
Sensors are less effective if dirty or used on carpeted / reflective floors. Place physical barriers or set a
“No-Go” zone to block off areas where RoboVac may fall.
d
e
f
Important Tips Before Use
Preparation
1
Remove the foam blocks beside the bumper and all the protective films before use.
To Next Page
Loading...
