Euroscan MX1 - Functionality Check - Onboard Status Leds

Euroscan MX1 15
Document number: EN-301-1:UD - based on Firmware version 1.033 and forward
3.1 Functionality check – onboard status LEDs
After the physical installation of the MX1 recorder has been established, the functionalities of the MX1 should be
inspected. Two on-board led’s (a green one and a red one) inform you about the status of the recorder. The table
below shows the meaning of both LEDs.
General
information
Power mode
Battery mode
GREEN
RED
Fridge
connection
(if installed)
Remote sensor
(if installed)
iGPRS
(if installed)
Initializing
after power on
OFF
Blinking
fast
System OK
Vehicle/fridge
battery in use
NOT charging /
NO battery
installed
Blinking
slow
System OK
Vehicle/fridge
generator in
use
NO battery
installed
Blinking
fast
System OK
Vehicle/fridge
generator in
use
Charging
ON
Blinking
fast
OFFline
(no connection
with server)
Blinking
slow
NO fridge
connection
NO remote
sensor
connection
ONline
(connection with
server)
OFF
Fridge
connection
OK
Remote sensor
OK
ONline
(connection with
server)
Backup
power in use /
power failure
NOT charging /
NO battery
installed
OFF
OFF
Failure during
initialization
ON
Table 1 LED’s status information
If only one of the two LED colours is mentioned in the table, it means that the other colour is not significant for the
status.