Euroscan MX1 - Igprs & Bluetooth Setup by Using Eurotool

Euroscan MX1 10
Document number: EN-301-1:UD - based on Firmware version 1.033 and forward
2.8 iGPRS & Bluetooth setup by using EuroTOOL
iGPRS and Bluetooth technology in combination with your Euroscan MX1 recorder will reduce time needed to
extract data from your vehicles and provide a quick analysis of transport data. This chapter describes the settings
of the Bluetooth and iGPRS parameters by using EuroTOOL.
Before starting the following information is needed:
iGPRS (when installed on the recorder):
Information from your SIM card provider:
 APN Server: Access Point Name, address from the server of the SIM provider.
 APN User name
 APN Password
 DNS: Domain Name Server. It’s the internet address translator that translates a word IP into address.
For example www.google.nl = 66.249.93.147
Information from Euroscan or the end user:
 When known, Customer ID. IF not, then the following information.
 TCP: Transmission Control Protocol, server address of our web solution or server address of the end user
(EuroLOG)
 TCP port: Channel number to get on the TCP server
Bluetooth (when installed on the recorder):
Information from the end user:
 IP-address(es) of the Local Access Point(s).
 PIN-code of the Local Access Point(s)
Fill in the form in appendix E to have all these important information in your vicinity.
Make sure the recorder is connected to your pc and the recorder is powered by a 10-36V DC source. See
chapter 2.5 and 2.6.