Euroscan MX1 - Appendix Bfunctional Specification

Euroscan MX1 19
Document number: EN-301-1:UD - based on Firmware version 1.033 and forward
APPENDIX B FUNCTIONAL SPECIFICATION
Temperature logging
 6 sensors, interval from 1..60 minutes, at -40 ºC to +50 ºC
 6 sensors through external equipment (fridge
controllers/Euroscan recorders), interval from 1..60 minutes,
 at -40 ºC to +50 ºC
Event logging
 Digital events (on/off)
 Alarm events (temperature to high/low, digital too long on/off)
 Diagnostics events (power on/off/dip, firmware update, security,
error codes)
 GPS events (km/miles moved, vehicle stopped/started moving,
GPS on exception (other event), speeding)
 Change of temperature alarm settings (upper/lower boundaries)
 Fridge set-point (change of set-point)
 Fridge communication (available/not available)
GPS logging
Logging interval from 5..75 minutes
External Equipment (protocols)
 Euroscan protocol: programming/downloading data, firmware
update
 MX1 debug protocol: terminal protocol for installation
diagnostics
 ThermoKing fridge protocol (through ThermoKing I-box): set-
points, sensors (return air), alarm doses, engine/maintenance
hours
 Carrier fridge protocol: set-points, alarm codes,
engine/maintenance hours
 Mitsubishi fridge protocol: set-points, alarm codes,
engine/maintenance hours
 TranScan protocol: temperatures/digitals (remote sensor
module)
 Old Euroscan protocol: current temperatures/digitals
Power mode / Communication mode
Power safe mode: iGPRS / GPS / Bluetooth can be switched on/off
based upon parameters or available power.