Euroscan MX1 - Introduction

Euroscan MX1 4
Document number: EN-301-1:UD - based on Firmware version 1.033 and forward
1. Introduction
This manual is a guideline for the installation and use of the Euroscan MX1. To avoid guarantee exclusion due to
incorrect installation, it is most essential to follow the instructions and recommendations of this manual.
The Euroscan MX1 is a modular device with different communication options. It is developed and produced to
meet the applicable European and National guidelines for the delivery of chilled and frozen transport goods in
transport vehicles.
The Euroscan MX1 can provide evidence of correct temperatures for every trip in the form of stored data with a
date/time stamp in a large flash memory. Data will not be lost when power supply is disconnected. The real time
clock is powered by an internal battery.
IMPORTANT: Data Security
Although the Euroscan MX1 recorder has been specifically designed and tested for use in harsh vehicle
environment, certain circumstances, where data loss could occur are beyond our control, i.e. lightning strikes,
high voltage peaks, theft, manipulation, etc.
Because the temperature data might be crucial to providing evidence in the case of transport damages, we
strongly advise to take the following precautions:
 Download data to a PC on a weekly basis as a back up.
 For a long-term storage of the data we recommend to download the data into the Euroscan EuroLOG
software via one of the communication options offered by Euroscan. In addition to RS232 connection,
Euroscan offers a variety of communication options for automated data transfer from the recorder to the
different Euroscan software options. For further information please contact the Euroscan Sales team or visit
our website: www.euroscangroup.com.
 Frequently check the correct functioning of the recorder (at least together with the fridge service).
 Check the recording system every 12 months to see if the measurement is within the legal error limit. The
annual test is an obligation according to EN 12830 or EN 13486, respectively.
 Before welding: disconnect the power from the Euroscan recorder or the vehicle.
 Do not use the power supply from a generator system without extra filter protection against high voltage
peaks. Preferably use battery power from the vehicle or fridge.
 Follow the installation and user instructions in this manual.
Precautions
Before installing this product start by attentively reading all installation steps.
Keep metal objects away from the recorder as far as possible. Metal in front of the recorder will reduce
radiated signal-power and may even prevent all communication!!!
For a proper functioning of the iGPRS and Bluetooth communication, the recorder should be mounted as
high as possible on the vehicle. The internal antennas should have a ‘clear view’ over the area around it.