4.5.4. Commission EVBox Iqon
Make sure that Iqon is registered with the CMP before you connect power (see Register EVBox Iqon
with CMP on page 34).
1. Switch on electrical power to Iqon.
Iqon powers up and runs the start-up sequence.
Bluetooth is activated and Iqon searches for the device that is running the EVBox Connect app.
2. On your smartphone or tablet, switch on Bluetooth and open the EVBox Connect app.
3. Select START PAIRING in the app.
A list of charging stations is shown.
4. Select the Iqon Bluetooth ID.
The LED ring shows flashing purple when pairing using Bluetooth is active.
5. Select the Iqon Bluetooth ID and follow the instructions in the app. The following details from the
Iqon configuration sticker (see Configuration details on page 34) are required for the app:
• The product Bluetooth ID.
• The product security code.
6. Use the app in the Installer mode to configure the following settings:
a. For a charging installation connected using the pre-programmed SIM:
◦ The applicable Charging Management Platform (CMP). (Do not manually add the CMP
URL.)
◦ The charge current.
4. Installation instructions
EN
35
To Next Page
Loading...
