b. For a charging installation connected to Wi-Fi:
◦ The Wi-Fi connection.
◦ The applicable Charging Management Platform (CMP). (Do not manually add the CMP
URL.)
◦ The charge current.
c. The following settings can also be configured using the app:
◦ Charger Access Control. Select the required access control for the charging station.
◦ LED Ring brightness.
◦ LED Ring ON or OFF when Iqon is in idle mode.
◦ Charging station name.
◦ Adding and removing charge cards.
◦ Updating the firmware.
7. Follow the instruction in the app to reboot Iqon.
Iqon is connected to a CMP and is ready to use.
4.5.5. Commissioning report
Complete the Commissioning Report that is supplied with Iqon. For a Hub-Satellite installation,
complete only one report. Send a copy of the report to the CPO. The installer should keep the original
of the report.
EN
4. Installation instructions
36
To Next Page
Loading...
