Step 8 - Set Minute:
The current minutes will flash. If the voice function
is on, the meter will say, “Set Minutes.” Press
▲or▼ to select the correct minutes. Press Enter (
) to confirm your choice and finish setting the
clock.
NOTE:
• Anytime during set up, inserting a EvenCare G2 Test Strip will
begin testing. Any changes made so far are stored.
• You may need to reset time after changing batteries.
After date and time has been set, the meter will announce the date
and time if the voice feature is on. Begin testing by inserting an
EvenCare G2 Blood Glucose Test Strip (see page 30, Testing Your
Blood Glucose), or press and hold Enter ( ) to turn off the meter, or
see the next section on how to set up the alarm feature on your meter.
EvenCareG2
Setting Up Your New System
15
To Next Page
Loading...
