5 For Professional Technical Support call 1-844-241-5521
Operation
NOTE: This unit is non-submersible. The pump should not be installed in a manner that will subject it to flooding, splashing or spraying.
1
Mounting the pump
2
Connecting the air conditioning
condensate drain tubing
The tank has two slots (1) provided to mount the unit. The slots
are located on the back of the tank. Mount the unit either on the
side of the air conditioner unit or nearby wall.
The pump must be level and the inlet must be below the coil
drain. Conduit fittings are not compatible with the plastic pump
housing.
Ensure the tubing to the pump intake is fastened securely so that
it cannot come out of the pump intake port.
Cut the tubing at an angle so that the bottom of the reservoir
does not close the tubing outlet. Be sure the tubing does not
interfere with the float.
3
Connecting the tubing
4
Plugging in the pump
Connect the tubing from the pump discharge hose barb to the
floor drain, laundry tub, or sink. Leave an air gap above the tub
drain.
Plug the pump power cord into a 115 volt properly grounded
power outlet.
To Next Page
Loading...
Need help?
General
