Safety Information (continued)
WARNING: This unit is designed only for use on
115 volts (single phase), 60 Hz, and is equipped
with an approved 3-conductor cord and 3-prong
grounded plug. DO NOT REMOVE THE GROUND
PIN UNDER ANY CIRCUMSTANCES. The 3-prong
plug must be directly inserted into a properly
installed and grounded 3-prong, grounding-type
receptacle. Do not use this pump with a 2-prong
wall outlet. Replace the 2-prong outlet with a
properly grounded 3-prong receptacle) installed in
accordance with the National Electrical Code and
local codes and ordinances. All wiring should be
performed by a qualified electrician.
WARNING: Do not use the power cord or discharge
hose to carry or handle the pump. Doing so may
cause damage to the power cord or discharge hose.
Use the handle supplied with the pump.
WARNING: Secure the discharge line before
starting the pump. An unsecured discharge line will
whip, possibly causing personal injury or property
damage.
WARNING: Release all pressure and drain all water
from the system before servicing any component.
WARNING: Wear safety goggles at all times when
working with pumps.
WARNING: When possible, connect the pump
DIRECTLY to a grounded outlet. Extension cords
may not deliver sufficient voltage to the pump motor.
Extension cords present a life-threatening safety
hazard if the insulation becomes damaged or the
connection ends fall into water. If using 25 ft.
extension cord, use 16-gauge wire or thicker.
WARNING: Protect the electrical cord from sharp
objects, hot surfaces, oil, and chemicals. Avoid
kinking the cord. Do not use damaged or worn
cords.
WARNING: Ensure that the electrical circuit to the
pump is protected by a 15-amp minimum fuse or
circuit breaker.
WARNING: Try to keep the pump as straight as
possible. Do not suspend the pump by the
discharge hose or power cord. Keep the pump
intake clear.
CAUTION: Periodically inspect the pump and
system components to ensure the pump intake is
free of mud, sand, and debris. Disconnect the pump
from the power supply before inspecting.
CAUTION: Know the pump and its applications,
limitations, and potential hazards.
CAUTION: Follow all electrical and safety codes,
particularly the National Electrical Code (NEC) and
in the workplace, the Occupational Safety and
Health Act (OSHA).
IMPORTANT: Ensure the electrical power source is
adequate for the requirements of the pump.
IMPORTANT: For safety, this pump motor has an
automatic resetting thermal protector that
automatically turns the pump off if it becomes too
hot. Overuse of this feature will damage the
pump and will void the warranty.
IMPORTANT: This pump is made of high-strength,
corrosion-resistant materials. It will provide trouble-
free service for many years when properly used and
maintained. However, inadequate electrical power
to the pump, or blockage by ice, dirt, or debris may
cause the pump to fail. Please carefully read the
manual and follow the instructions regarding
common pump problems and remedies.
IMPORTANT: This pump is not intended for use in
sewage or septic systems. Doing so will void
warranty.
IMPORTANT: This pump is not intended to be used
as a permanently installed sump pump. Use as a
sump pump will void the warranty.
The manufacturer warrants to the original purchaser that it will be free from any defect in materials and/or workmanship
for one (1) year from date of purchase. This limited warranty is extended ONLY to the original purchaser, and only covers
products purchased as new. If during this one-year period, the original purchaser experiences a defect which is covered
by this limited warranty, it will be repaired or replaced (at manufacturer’s sole option) at no cost to the purchaser.
Defective parts will be repaired or replaced with new or factory rebuilt parts at the manufacturers’ sole option.
Please contact 1-844-883-1872 for further assistance.
To Next Page
Loading...
Need help?
General
