properly grounded outlet.
WARNING: Do not allow the plug to fall in the water
and do not stand in the water or on a damp surface
while the pump is plugged in. Do not handle the
plugged-in pump with wet hands.
The sensor is located on the side of the
pump. Keep the surface of sensor clean so the
sensor can operate properly.
Please contact 1-844-883-1872 for further assistance.
When the water level rises to 1-1/4 in., the pump starts.
When the water level drops to 1/4 in., the pump stops.
ON water level 1-1/4 in.
OFF water level 1/4 in.
When the water level drops to 1/4 in. and the pump does
not stop, no-load protection intervenes to stop the pump.
When no-load protection intervenes, after stopping the
pump, it will start the pump once (5 seconds) at an
interval of 5 minutes, until the sensor works properly.
To reset the sensor manually, unplug the pump and
clean the sensor. Be sure to clean the volute and
impeller clear of debris and make sure that the weep
hole is clear.
To Next Page
Loading...
Need help?
General
