EverFocus EPTZ3600 - Page 46

46
In zone menu, you can set a zone and name it, when the speed dome turns to the zone
you set, it will display zone name on the screen (only if “OSD/AREAS->Display -> Zone” is
set as “YES”). Tilt the joystick up and down to scroll through the characters, then tilt left or
right to move to the previous/next position. When finished, tilt the joystick right to go to
"Range" section, and press Enter key to enter Range sub-menu. Use the joystick to move
speed dome to its left position. Press IRIS+ key to save left position setting and go to next
step or press IRIS- to cancel.
(diagram 3.10)
Use the joystick to move speed dome to its right position. Press IRIS+ or IRIS- key to save
and return.
(diagram 3.11)
ZONE1
MOVE TO LEFT POSITION
IRIS+: SAVE AND NEXT STEP
IRIS-: CANCEL
ZONE
TITLE RANGE CLR
1. ---------------------------- --------<┘ [<┘]
2. ---------------------------- --------<┘ [<┘]
3. ---------------------------- --------
<┘ [<┘]
4. ---------------------------- --------
<┘ [<┘]
5. ---------------------------- --------
<┘ [<┘]
6. ---------------------------- --------
<┘ [<┘]
7. ---------------------------- --------
<┘ [<┘]
8. ---------------------------- --------
<┘ [<┘]
RETURN
ZONE1
MOVE TO LEFT POSITION
IRIS+: SAVE AND NEXT STEP
IRIS-: CANCEL
ZONE1
MOVE TO RIGHT POSITION
IRIS+/IRIS-: SAVE AND
RETURN