4. EPTZ3600/3600I FUNCTION SETUP AND OPERATION
4.1. Manual Control Mode
Manual control: Shift Joystick Up/Down/Left/Right, and turn it
Clockwise/Counterclockwise to control speed dome.
Use the control keys which are Zoom, Focus and IRIS function keys on the
keyboard to Zoom In/Out, focus N (near)/F (Far), or IRIS +/-.
Note: Zoom In/Out control keys will be disabled when entering to OSD menu
mode.
HOME Mode: The camera view will go back to the home position when there is no
keyboard operation in a specific time. The home position and the specific time can
be set by pressing Set + Home.
If you set the time to 0 minute, then the camera will go back to home if there is no
keyboard operation in 5 seconds. This is the minimum no action time for HOME
mode.
Note: If "HOME" function is enabled, dome will go to home immediately after
powering on.
4.2. Auto Tracking Mode (For Auto Tracking Models Only)
User can control “auto tracking” on or off by pressing “81” and Enter key.
User can set “manual select object” on by pressing “82” and Enter key.
Camera can directly go to tracking start point by pressing “83” and Enter key.
4.3. Auto Pan Mode
Two point auto pan: Press A.Pan to enter the auto pan mode, and then the system
will ask you to enter the auto pan speed (1~239). Press Enter to start auto pan.
In order to set the two points, press Set + A.Pan, and then enter the dwell time
(1~127 seconds) of each point. EPTZ3600 begins to pan from point A to point B
To Next Page
Loading...
