when an alarm is triggered.
Set an alarm link:
Press F1 to set an alarm link. Enter the alarm number, and then press Enter.
Switch the Joystick up/down to select a position or a tour, enter a position or tour
number, and then press Enter to confirm the alarm link setting.
If you set the position number to 99, the dome will do a 360 degree auto scan or
AB two point pan if limit is ON. If you set the position number to 98, the dome will do
a frame scan.
Delete an alarm link:
Press Clr + F1 to delete a link of alarm to position/tour.
Note 1: After alarm output signal is terminated, the speed dome will resume action
or return to its original position.
Note 2: After powering on the speed dome, it will detect alarm status automatically.
4.7. Other Operations
The EPTZ3600/EPTZ3600I can work with a DVR that has PTZ control functions, and
a matching protocol. The available control functions depend on different DVRs.
The EPTZ3600/EPTZ3600I can work with a keyboard that has PTZ control functions,
and a matching protocol. The available control functions depend on different
keyboards.
To Next Page
Loading...
