Everglades 335 CC - Page 75

75
Electrical System
Baitwell Pump
Activates the pump that supplies seawater to the
baitwell.
Fishbox Pump
Activates the macerator pump that drains the forward
shbox.
Windlass Up/Windlass Down
Two momentary switches that control the wind-
lass, which is mounted to the deck forward of the
rope locker. Touch and hold the WINDLASS DOWN
switch to pay the anchor line out. Touch and hold
the WINDLASS UP switch to pull the anchor line
in. The switches return to the OFF position when
released.
Windlass Enable
Activates the windlass up/down switches.
Wiper HI/INT/LOW Switches
Activates the windshield wiper and selects wiper
speed and mode.
Intermittent Speed
Two momentary switches that control time between
wipes when wiper intermittent mode is selected.
FRT Wind UP/DN
Two momentary switches that activate the hy-
draulic rams that raise and lower the windshield
to provide ventilation for the helm area and/or
improve visibility. Touch and hold the DOWN switch
to lower the windshield. Touch and hold the UP
switch to raise the windshield. The switches return
to the OFF position when released.
Light Bar
Activates the overhead lights at the front of the
hardtop that illuminate the area forward of the bow.
Wiper - One Swipe
Touch to activate the wiper for one swipe.
Wiper - Wash
A momentary switch that activates the solenoid
that sprays water on the windshield washer from
the fresh water system.
Notice:
The fresh water system must be activated for
the windshield washers to work.
Hardtop Lights
Activates the lights in the hard top above the Helm.
Ctsy Lights
Activates the lights in the cockpit below the gunnels
that illuminate the cockpit sole.
FWD Light Bar
Activates the overhead lights at the front of the
hardtop that illuminate the area forward of the bow.
FWD Light Bar Reduced PWR
Activates light bar at reduced intensity.
Lights Dimming % Controls
Adjusts the intensity of the lights named below
the control. Touch and slide the switch starboard
to increase brightness. Touch and slide the switch
port to decrease brightness. Intensity is indicated
above each control.
Spreaders Reduce PWR
Reduces spreader light intensity.
All Spreaders O
Touch to turn all spreader o simultaneously.