DARNING STITCH
3.5~7.0
1.5~2.0
D
23
24
1 Select the pattern 23 or 24 to get the
darning stitch. Change the presser foot to
the buttonhole foot.
1
2 Baste the upper fabric and the reinforcement
fabric together. Select the width of the
pattern by using the stitch width button.
Lower the presser foot over the center of the
tear.
3. Pull the button holder to rear. Set the button
guide plate on buttonhole foot to the
desired length.
4. The size of the darning cycle is variable.
However, the maximum stitch length is
2.6cm (1 inch) and the maximum stitch
width is 7mm (9/32 inch).
a. The length of darning pattern.
b. The width of darning pattern.
4
Start
a
b
StopStop
a
Start
b
2
3
4
1
NOTE
Make no
gap here
3
2
49
To Next Page
Loading...
