WARNING FUNCTIONS
Lowering the buttonhole lever
When you select any buttonhole pattern or darning
pattern, LCD screen will show the figure " ". It is
to remind you to lower the buttonhole lever.
Bobbin winding
When the bobbin winder spindle is activated for
bobbin winding (in the rightmost position) this
appears on the LCD screen as a reminder.figure
Instruction message display
- When operating correctly: 1 beep
- When the memory is full 30 units of pattern: 3-short beeps
- When operating incorrectly: 3-short beeps
- When the sewing machine is in trouble and can't sew: 3-short beeps
It means that the thread is twisted or jammed and the hand wheel axle can't move. Please look
through the "Trouble shooting guide" on page 72/73 to find the solution. After the problem has
been solved, the machine will continue to sew.
Warning beeping sound
Please Note: If the problem is not resolved, please contact your local dealer.
Attention: If the thread gets jammed inside the hook during sewing, stopping the needle
from moving, the security switch will stop the machine completely. In order to restart the
sewing machine, you will have to turn the on/off switch to the OFF position and then ON
again.
Return bobbin winder shaft to left
If the bobbin winder shaft is positioned to the
right (engaged) and any button is pressed a 3-
beep warning will be sounded. Move bobbin
winder shaft to the left (disengaged) to allow
the buttons to be operational.
69
To Next Page
Loading...
