EverSewn Celine - Trouble Shooting Guide

TROUBLE SHOOTING GUIDE
Seam
puckering
1.The needle thread tension is too tight.
2.The needle thread is not threaded
correctly.
3.The needle is too heavy for the fabric
being sewn.
4.Stitch length is too long for the fabric.
1.Loosen the thread tension.
2.Rethread the machine.
3.Choose a needle to suit the thread and
fabric.
4.Shorten stitch length
Problem
Cause
Correction Reference
Page 22
Page 16
Page 25
Page 32
Patterns are
distorted
1.The correct presser foot is not used.
2.The needle thread tension is too tight.
3.The stitch length is not suitable for the
fabric being sewn.
1.Select the correct foot.
2.Loosen the thread tension.
3.Make a stitch adjustment and add
stabilizer to the fabric.
--
Page 22
Page 32
The machine
jams
Remove the upper thread and bobbin
case. Turn the handwheel backwards and
forwards by hand and remove the thread
remnants.
1.Lint or oil have collected on the hook or
needle bar.
1.Clean the hook and feed dog as
described.
1.Thread is caught in the hook.
2.The feed dogs are packed with lint.
Page 26
Page 71
The sewing
machine
doesn't
operate
1.The machine is not turned on.
2.The Start/stop button was not pressed.
3.The presser foot lever is raised.
5.A thread is caught in the hook race.
1.Turn on the machine.
2.Press the Start/stop button.
3.Lower the presser foot lever.
5.Remove the upper thread and bobbin
case. Turn the handwheel backwards
and forwards by hand and remove the
thread remnants.
The machine
is noisy
2.The needle is damaged. 2.Replace the needle.
Uneven
stitches,
uneven feed
1.Poor quality thread.
2.The bobbin case is threaded wrong.
3.Fabric has been pulled.
1.Select a better quality thread.
2.Remove the bobbin case, the thread
and reinsert correctly.
3.Do not pull on the fabric while sewing,
let it be taken up by the machine.
4.Thread is caught in the hook.
3.Slight humming sound coming from
internal motor.
3.Normal.
5.The feed dogs are packed with lint.
Remove the upper thread and bobbin
case. Turn the handwheel backwards and
forwards by hand and remove the thread
remnants.
6.Connect the power line plug to the
electric outlet.
6.The machine is not plugged in.
Page 15
--
Page 71
Page 25
Page 12
--
Page 28
Page 20
Page 71
Page 12
Page 71
73