Evh HARDEE LR50160 - User Manual

Questions and Answers

D
Daniel CarrollAug 21, 2025
Why won't the cylinder operate on my Evh HARDEE LR50160 Lawn Mower?
- R
  ronaldcherryAug 21, 2025
  If the Evh Lawn Mower cylinder does not operate, it could be due to several reasons. First, check if there is power to the joystick, and repair or replace connections if needed. Second, examine the fuse inside the lighter plug and replace it if it's blown. Third, ensure the joystick is connected to a 12-volt system. Also, verify the joystick is connected to the valve, examining the bulkhead connection to the mower. Lastly, the proportional valve may not be functioning; in this case, repair the electrical connections to the solenoid or replace the solenoid.
H
hgarciaSep 3, 2025
Why does the boom operate erratically on my Evh HARDEE LR50160?
- A
  Alyssa GonzalezSep 3, 2025
  If the Evh Lawn Mower boom operates erratically, the speed may be too fast. Other causes may be a defective controller, air in the lines, or trash in the proportional valve.
R
Roy KnappSep 1, 2025
Why does my Evh HARDEE LR50160 head grind and roar when operating?
- E
  ericwhiteSep 1, 2025
  If the Evh Lawn Mower mower head grinds and roars during operation, it is likely due to worn bearings or improper lubrication in the mower hydraulic motor housing. Repair or replace components such as bearings, seals, and the housing as needed.
K
Kelly DiazAug 30, 2025
Why does the motor seal continually blow out on my Evh HARDEE LR50160 Lawn Mower?
- B
  Beverly CastilloAug 31, 2025
  If the Evh Lawn Mower motor seal continually blows out, it is likely due to a damaged internal poppet valve. Replacing the poppet valves should resolve this issue.
G
gdelgadoAug 29, 2025
What to do if the filter gauge is in the red at all times on my Evh HARDEE LR50160 Lawn Mower?
- B
  Bradley HowardAug 29, 2025
  If the Evh Lawn Mower filter gauge is always in the red, it could be due to a restricted filter, which would require repair or replacement. Another possibility is a bad gauge, also necessitating repair or replacement. Finally, the hydraulic oil might be too heavy for the region or climate, in which case you should replace the oil.
J
Jessica MillerAug 27, 2025
Why do the blades loose speed in mowing with my Evh HARDEE LR50160 Lawn Mower?
- J
  Jennifer SullivanAug 27, 2025
  If your Evh Lawn Mower blades lose speed while mowing, the issue could stem from an improper relief valve setting. In such cases, check the relief valve setting. Alternatively, there might be trash in the proportional valve, necessitating a check or replacement. Lastly, examine and replace the poppet valves in the motor if needed.
W
William HallAug 26, 2025
What to do if my Evh HARDEE LR50160 Lawn Mower vibrates severely?
- F
  Frederick GarciaAug 26, 2025
  If your Evh Lawn Mower unit vibrates severely, it could be due to a broken blade, which requires replacing the blades, blade bolts, and nuts. Another cause could be mismatched or unbalanced blades. Also, check for a loose blade holder, repairing or replacing it as necessary. Finally, a loose output shaft may be the culprit, in which case you should repair or replace the shaft's bearings in the mower head housing.
S
Samantha OliverAug 25, 2025
Why does my Evh HARDEE LR50160 Lawn Mower motor whine?
- V
  Vernon StevensAug 25, 2025
  If the Evh Lawn Mower motor whines, it may be due to a worn or damaged motor, requiring repair or replacement. Another potential cause is improper oil in the system, which can be resolved by replacing the oil. Additionally, the pressure setting on the relief valve might be too low.
J
Jamie SotoAug 22, 2025
Why does my Evh HARDEE LR50160 pump whine?
- A
  allenchristopherAug 23, 2025
  If the Evh Lawn Mower pump whines, it could be due to a worn or damaged pump, which would require repair or replacement. Make sure the gate valve is open. Another possible cause is improper oil in the system, in which case you should replace the oil. Finally, the pressure setting on the relief valve might be too low.