24
ADVANCED CLEANING (continued)
9 Remove the "T" card then remove the film from the adhesive cleaning card
1
and insert it into the feeder as shown, adhesive side
up
2
. Cleaning starts.
10 The used adhesive card is automatically ejected into the output hopper.
Wait for 2 minutes after cleaning before using your printer. Before using your printer, remember to readjust the gauge to the desired
card thickness.
Please note the "T" shaped card must be used immediately after the bag is opened.
Advanced cleaning may also be launched from the Edikio Print Center by clicking on "Start cleaning".
NOTE
To Next Page
Loading...
Need help?
General
