7
Under no circumstances should you connect the USB data cable before the installation of the printer driver is complete.
To save energy, the printer will automatically switch itself to standby mode after 10 minutes of inactivity. It will switch to sleep mode
after 30 minutes in standby mode.
The standby times can be set up in the Edikio Print Center. In standby mode, sending a print request restarts the printer, and briefly
pressing the control button (for 1 second) takes the printer out of sleep mode.
Before attempting any maintenance, always ensure that the power cable is unplugged. For your personal safety, ensure that the
cable and power supply unit can be easily accessed, especially in the event of an emergency.
INSTALLATION
Connecting the printer
Connection to the power supply
Please refer to the section on printer driver installation in this chapter for further details, and follow the instructions carefully.
∙ Remove the sticker that covers the connection ports at the back of the printer.
∙ Connect the power cable to the power supply unit, then plug the power cable jack into the printer.
∙ Next, plug the end of the power cable into a grounded power socket.
∙ The printer is powered on: the printer touchscreen lights up showing that the printer is working properly.
If the touchscreen does not light up, then either the installation has not been carried out correctly or the
printer is not working properly. Check the installation.
The printer must be connected to a properly protected and grounded electrical installation.
FI: Laite on liitettävä suojamaadoitus koskettimilla varustettuun pistorasiaan.
NO: Apparatet må tilkoples jordet stikkontakt.
SE: Apparaten skall anslutas till jordat uttag.
DK: Printeren skal tilsluttes til en korrekt beskyttet og jordforbundet el-installtion.
Connecting the USB cable
To Next Page
Loading...
Need help?
General
