26
Servicing the dust filter
The dust filter is located above the ventilator for the print head. This filter can get dirty over time. We recommend cleaning it once a year or after
10,000 cards, depending on your work environment.
1 Open the printer cover. Locate the dust filter.
2 Remove the filter by pulling it up and sliding to release it completely.
3 Once the filter has been removed, take one of the Evolis High Trust
®
cleaning wipes.
4 Clean the filter by brushing it with the wipe on each side.
5 To put it back, insert it in place (groove facing you) and push it down until it clicks into position.
6 Close the cover.
1
2
3
4
5
6
To Next Page
Loading...
Need help?
General
