7
1?3 Installation
1?3a CONNECTING THE PRINTER
³
Connection to the power supply
The printer must be connected to a properly protected and earthed electrical installation.
FI: Laite on liitettävä suojamaadoitus koskettimilla varustettuun pistorasiaan.
NO: Apparatet må tilkoples jordet stikkontakt.
SE: Apparaten skall anslutas till jordat uttag.
Connect the power cable to the power supply unit, then plug the power supply unit
connector into the printer.
1H[WSOXJWKHHQGRIWKHSRZHUFDEOHLQWRDQHDUWKHGSRZHUVRFNHW
The printer is powered on: the control panel lights up showing the printer is working
properly. If the control panel does not light, then either installation has not been carried
out correctly or the printer is not working properly. Check the installation.
Before attempting any maintenance, ensure that the power cable is always unplugged. For your personal safety,
ensure that the cable and power supply unit remain easy to access, especially in the event of an emergency.
To save energy, the printer will automatically switch itself to standby mode after 10 minutes of inactivity. The printer
switches to hibernation mode after 30 minutes in standby mode.
7KHVWDQGE\WLPHVFDQEHFRQÀJXUHGLQWKH(YROLV3ULQW&HQWHU,QVWDQGDUGVWDQGE\PRGHVHQGLQJDSULQWUHTXHVW
UHVWDUWVWKHSULQWHUDQGTXLFNO\SUHVVLQJIRUVHFRQGRQWKHEXWWRQH[LWVWKHSULQWHUIURPKLEHUQDWLRQPRGH
.
³
Connecting the USB cable
Under no circumstances should you connect the USB data cable before installation of the printer driver is
complete.
Refer to the section on printer driver installation for further details, and follow the instructions carefully.
1
To Next Page
Loading...
Need help?
General
