Evolis Elypso - Contactless Smartcard Encoding; RFID Encoding Module and Antenna

59
C1c ? CONTACTLESS SMARTCARD ENCODING
Evolis printers may be equipped with an encoding device for contactless smartcards (RFID). This consists of an encoding module and a
builtNin antenna.
A module such as this must be installed by a specialist. The Evolis product catalogue includes printers equipped with a builtNin encoder
for contactless chips.
This encoder connects to the PC via a USB interface.
7KHUHLVDYHU\ZLGHYDULHW\RIFRQWDFWOHVVVPDUWFDUGVDQGHDFKFDUGKDVVSHFLÀFWHFKQLFDOSURSHUWLHVDVVRFLDWHGZLWKDQHTXDOO\VSHFLÀF
type of encoder. See your Evolis dealer for further information.
³
Location of the antenna (or the encoder including an antenna)
%\PHDQVRIDVSHFLÀFFRPPDQGWKHFDUGLVSRVLWLRQHGFORVHWRWKHDQWHQQDVXFKWKDWWKHFDUGOLHVZLWKLQLWVUDGLRUDQJH
Reading data from or writing data to the card can then start.
The programming sequence for a chip is always carried out before the card is printed.
³
Card positioning
There is in theory no restriction on card positioning when programming in contactless mode.
+RZHYHUWKHPLQLDWXULVDWLRQRIFRPSRQHQWVLVEULQJLQJDERXWWKHHPHUJHQFHRIFDUGVÀWWHGZLWKPLQLDQWHQQDH
If this is the case, please see your card supplier for further information about where such miniNantennae are located within the card, so as
to position the card as close as possible to the encoder’s antenna. Doing so will ensure optimum encoding of the cards.
C