³
Removing printed cards
Once the print and/or encoding cycle is complete, cards are delivered into the output stack found on the left of the device. This has a
capacity of 500 x 0.76 mm (30 mil) cards.
Remove the card output stack by pressing both release buttons
Open the card output stack door, and raise the weight.
Remove the cards, then lower the weight back down and close the card output stack.
Put the output stack back into the printer (door facing outwards), clicking it into position.
It is possible to eject a printed card into the reject hopper rather than the output stack.
To cause a card to be ejected into the reject hopper, simultaneously press both outside buttons on the control
panel.
The following message appears: ‘Next card ejected into reject hopper’. You then have one minute to start your
print run.
1
10
To Next Page
Loading...
Need help?
General
