Evolis Tattoo - Page 12

For the users operating under Windows with a USB interface :
1. Install the printer driver by following the instructions given in the previous section « For the
users operating under Windows ».
2. Install the USB driver :
– Check that the Tattoo printer is powered ON.
– Connect the USB interface cable to your computer then to the appropriate printer port.
– The « Add New Hardware Wizard » window is displayed. Then click on the « Next »
button.
– Click on the option which invites you to search the best driver for your peripheral and
then click on the « Next » button.
– Select the « CD-ROM Drive » option and click on the « Next » button.
– Click on the « Next » button. The USB driver is now installed.
– Follow the instructions displayed on the screen.
3. Set the printer port of your computer :
– After having reboot your computer, click on « Start » and in « Parameters » select
« Printers ».
– In the « Printers » window, select the « Evolis Tattoo » icon.
– In the « File » menu, select « Properties ».
– Click on the « Details » tab and select USB printer port in the list.
– Click on OK to close this window. The configuration is now finished.
12
IMPORTANT !
If your printer will be connected via a parallel interface cable, the
driver installation is finished.
If your printer will be connected via a USB interface cable, refer to
the next section « For the users operating under Windows with a
USB interface » for the instructions to be followed.